DuraVent DirectVent Pro 45 Degree Elbow: a gentler turn for getting around framing
The DuraVent DirectVent Pro 45 Degree Elbow is a bend in the vent pipe that helps route it around an obstruction. DuraVent recommends using two of these elbows to take the pipe around a joist or rafter. They restrict exhaust and incoming air less than a 90 degree turn. An elbow strap supports the pipe between the pair. DirectVent Pro is DuraVent’s pipe inside a pipe vent for direct vent gas fireplaces and stoves: exhaust goes out through the inner pipe and outside air comes in through the outer pipe.
The elbow turns on its base while the twist lock joint stays fully connected, so you can point it where the run needs to go. The bend itself stays at 45 degrees. Choose a 4 by 6 5/8 inch or 5 by 8 inch size to match your vent run, then select galvanized or painted black. Galvanized suits hidden runs, while black is for pipe visible in the room. Need a square turn toward the wall? See the DuraVent DirectVent Pro 90 Degree Elbow. The DuraVent DirectVent Pro 45 Degree Elbow ships free from My Cozy Outdoors with No Sales Tax (except WY) and the full manufacturer warranty.

















































